» Vessel Sealing System plus conventional Bipolar Coagulation
» Compatible with different types of sealing accessories
» Two vessel sealing modes allowing different types of surgical processes
» Bipolar Auto-start and Auto-stop mode for optimum tissue coagulation ( preventing tissue carbonization )
» Automatic self-checking (spotting the system’s internal problems)

» Ability of reliable sealing of large vessels and tissue bundles, up to 7 mm in diameter
» High-burst-strength. (Seals created by vessel sealing system can withstand pressure more than 3 times normal systolic pressure)
» Less tissue damage and reduced sticking and charring
» Reduction in surgical operating time especially in endoscopic/laparoscopic procedures
» No foreign material, using the body’s own collagen to seal the vessels
» Reduction in needle stick injuries, lowering the probability of transmission of Hepatitis and HIV
» Minimum thermal spread to adjacent tissue
» Applicable in both open and laparoscopic surgeries, using wide variety of instruments

Conventional Bipolar Coagulation:
» Continuous sine wave
» Bipolar coagulation with anti-sticking effect, without tissue carbonization
» Foot switch and auto-start (tissue sensor) activation for coagulation

Auto-stop System for Conventional Bipolar Coagulation:
» Tissue impedance sensor switches the generator off as soon as the coagulation reaches the optimum level, before carbonization or electrode sticking
» A fully automatic bipolar coagulation with forceps is possible without foot or finger switching

User Interface:
» Visual and audible indicators for activation
» Digital 7-seg for output power
» 4x20 characters STN LCD for monitoring errors, and messages

Basic construction: In compliance with IEC60601-1 & IEC60601-2-2
Protection class: Class I
Type of output: CF
Self-Check: Malfunctions are detected and recorded as codes
Dosage Rate Control: Automatic and permanent control of output power
LF Leakage Current:
» All patient terminals tied together
» Normal condition <10 µA
» Single fault condition <50 µA
HF Leakage Current: <20 mA

Frequency: 410 KHz ± 1%

	Mode	Max. Power (w)	Rated Load (Ohms)	Max P-P Voltage (V)	Typical Crest Factor
Conventional Bipolar Coag.	Manual Coag. Auto Start Coag.	100 50	100 100	370 370	1.5 1.5
Bipolar Vessel Sealing	Seal 1 Seal 2	250 235	25 25	375 375	1.5 1.5

Mains Voltage: 220 V AC ± 10%, 50 Hz (110V AC ±10% optional)
Maximum power consumption:   700 V.A
Main fuses:   2x5A standard
Weight:  8.8 kg
Dimensions: 37.1x15.9x46.5 cm